Installing Your Internal Tape Drive; Getting Started - Iomega 3151100 User Manual

Installing Your Internal Tape Drive

Installing Your Internal Tape Drive Installing Your Internal Tape Drive
Installing Your Internal Tape Drive Installing Your Internal Tape Drive
Using this section as a guide, you will be able to
install your new internal tape drive. Installation of
the tape drive requires three basic steps:*
1
2
3
To complete this project you will need a phillips
screwdriver and, perhaps, a flathead screwdriver. We
also recommend that you set your computer on a
table (not the floor) to install the drive.
*If you are installing a Ditto Dash accelerator card (an optional accessory for
the Ditto 2GB, Ditto Easy 3200, and Ditto Easy 800 drives), see the Ditto
Dash Installation Guide and install the card before installing the drive.
If you are installing the Ditto Max drive, follow the instructions in this
manual to install the Ditto Dash DX accelerator card.

Getting Started

Getting Started Getting Started
Getting Started Getting Started
Unpack the tape drive and accessories onto a table.
Caution: Touch a grounded metal object (like a metal cover screw on your
computer) to discharge personal static electricity before handling the tape drive.
Mounting Screws
Tape Drive
Tape Cable
Iomega Backup Software
14
Preparing your computer
Preparing the drive
Connecting the drive to the computer
(Actual contents may not match illustration)