Declaration Of Conformity - Iomega 3151100 User Manual

Ditto

Hide thumbs

Table Of Contents

Table of Contents

We, the undersigned, declare that the equipment specified below conforms to the following directives.

73/23/EEC, 89/336/EEC

Application of Council Directives

EN 55022, EN 50082-1, EN 60950, FCC-Pt15(b)

Declared Conformity to Standards

IOMEGA Corp.

Manufacturer's Name

1821 West Iomega Way, Roy, UT, USA

Manufacturer's Address

(801) 778-1000

Manufacturer's Telephone Number

IOMEGA International, S.A.

Importer's Name

Information Technology Equipment

Type of Equipment

United States FCC Information

The computer equipment described in this installation guide generates and uses radio

frequency (RF) energy. If the equipment is not installed and operated in strict accordance with

the manufacturer's instructions, interference to radio and television reception may result.

INTERFERENCE This equipment complies with Part 15 of the FCC Rules and its operation is subject to

the following conditions: (1) the equipment may not cause harmful interference, and (2) the equipment

must accept any interference received, including interference that may cause undesired operation.

Part 15, Class B, of the FCC Rules is designed to provide reasonable protection against radio

and television interference in a residential installation. Although the equipment has been

tested and found to comply with allowed RF emission limits, as specified in the above cited

rules, there is no guarantee that interference will not occur in a particular situation.

Interference can be determined by turning the equipment on and off while monitoring radio

or television reception. The user may be able to eliminate any interference observed by

implementing one or more of the following measures.

•

Reorient the affected device and/or its receiving antenna.

•

Increase the distance between the affected device and the computer equipment.

•

Plug the computer and its peripherals into a different electrical circuit from that used by the affected device.

WARNING Only the manufacturer's shielded host interface cable, or an equivalent

cable, is allowed for use with this product. Other types of cables will void the

manufacturer's warranty and violate FCC rules and regulations. Also, changes or modifica-

tions to the electronics or enclosure of this product must be expressly approved by Iomega;

otherwise, the user's authority to operate the equipment may be voided by the FCC.

Canadian DOC Information

The digital apparatus referenced in this guide does not exceed the Class B limits for radio noise

emissions from digital devices as set out in the Radio Interference Regulations of the Canadian

Department of Communications.

In North America this product is supplied with a UL-listed and Canadian-certified Class II power unit

with a rated output of 12V DC, 1.7A.

Iomega and the Iomega logo are registered trademarks of, and Ditto and the graphic swirl,

hand, and eye are trademarks of Iomega Corporation. All other company and product names

mentioned in this document are the property of their respective companies.

Your Iomega tape product uses intelligent circuitry to conserve electrical energy when not in

operation. The energy star emblem does not represent EPA endorsement of any product or

service.