Table of Contents
Advertisement
3. Remove foil hose and polystyrene
padding from the machine.
Electrical connection
Details on mains voltage, type of current and the fuses required should
be taken from the type plate. The type plate is fitted near the loading
aperture (see "Machine description" section).
Important:
The plug must be accessible after the appliance has been installed.
Changing door stop
1
Warning! The door stop may only be changed by a specialist.
If necessary, please contact our after-sales service or your specialist
dealer.
Warning! Before changing the door stop, disconnect the mains plug;
with a permanent connection: fully unscrew or deactivate the fuse.
1. Open loading door.
2. Unscrew hinge A from the front of
the machine and take off the load-
ing door.
3. Remove cover plates B and C. To do
this, insert a thin screwdriver into
the slots as shown in the illustra-
tion, press downwards slightly and
pry out the cover plates.
4. Use an appropriate tool and exert
pressure to unfasten locking block
D from the snap-on fixture, take
out and reinsert on the other side
having rotated the block through
180°.
33
Advertisement
Table of Contents
