Cleaning The Heat Exchanger - AEG Electrolux LAVATHERM 7071 TK ELECTRONIC User Information

Cleaning the heat exchanger

If the display shows PLEASE CLEAN THE CONDENSER, the heat exchang-
er must be cleaned.
1
Caution! Operating when the heat exchanger is blocked with fluff can
damage the dryer. This also increases energy consumption.
1. Open door.
2. Open door in plinth. To do this,
press the release button on the
bottom of the door aperture and
open the door in the plinth to the
left.
3. Clean fluff from the inside of the
door and the heat exchanger front
chamber. Wipe the door seal with a
damp cloth.
4. Turn both lock washers inwards.
5. Use the handle to pull the heat ex-
changer out of the base and carry
it horizontally to prevent any re-
maining water from spilling.
6. To empty the heat exchanger, hold
vertically over a washing-up bowl.
1
Caution! Do not use sharp objects
to clean. The heat exchanger could
develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse thoroughly with a hand-held shower.
8. Replace heat exchanger and lock into place (turn both lock washers
outwards until they snap into place).
9. Close door in plinth.
1
Caution! Never operate the dryer without the heat exchanger.
26