Table of Contents
Advertisement
Drying cycle complete / removing washing
If the audible signal is set, at the end of the programme a 4x signal
sounds and the display alternates between the messages "AN-
TICREASE", "PLEASE EMPTY THE TANK" and "PLEASE CLEAN THE FIL-
TERS" .
3
The drying cycle is automatically followed by a anti-crease phase which
lasts around 30 minutes. The drum rotates at intervals during this
phase. This keeps the laundry loose and free of creases. The laundry can
be removed at any time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-crease phase at the
latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter.
It is best to use a damp hand for this purpose (see "Cleaning and main-
tenance" section).
3. Remove laundry.
4. Turn the programme knob to OFF (AUS).
Important! After each drying cycle
– clean the micro-fine filter and fine filter,
– drain the condensed water container
(see section "Cleaning and maintenance").
5. Close door.
Setup
The special functions that can be set under Setup remain permanently
stored independent of each drying cycle – even after the appliance has
been switched off or the mains plug has been removed from the socket.
Memory 1, 2, 3
Programme combinations can be stored at programme knob positions
MEMORY 1, 2, 3 and can then be selected using the programme knob.
To do this, the desired programme combination is first put together and
then stored.
18
Advertisement
Table of Contents
