Table of Contents
Advertisement
5. Unscrew hinge A from the loading door, rotate through 180°, reinsert
on the opposite side and screw down.
6. Reinsert cover plates B and C on the opposite site having first rotated
them through 180°.
7. Unscrew cover plates E from the
front of the machine, rotate
through 180°, screw on the
opposite side.
8. Unscrew door lock F, push down
slightly and remove from the front
of the machine.
9. Disconnect cable connector from
door lock F.
10. Press snap-in button G in and
down, press cover down slightly
and remove from front of the ma-
chine.
11. Disconnect cable connector from
cover G.
12. Change door lock F over to the op-
posite side, insert the cable con-
nector and screw down the door
interlock.
13. On the other side, insert the cable connector in cover G, insert cover
and allow snap-in button to lock into place.
14. Insert loading door and hinges into recesses on the front of the ma-
chine and screw down.
15. Once the door stop has been replaced, check the function of the DOOR
(TÜR) button.
Note regarding contact protection: The machine is only secure for
operations again once all plastic parts have been inserted.
34
Advertisement
Table of Contents
