Electrical Connection; Permanent Connection; Door Reversal Instructions - AEG Electrolux LAVATHERM T57830 User Information

125985010 gb.qxp 2006-06-12

Electrical connection

Any electrical work required to install this appliance should be carried out by a
qualified electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be observed.
Should the appliance power supply cable need to be replaced, this must be
carried out by our Service Centre.
Before switching on, make sure the electricity supply voltage is the same as that
indicated on the appliance's rating plate. (See picture on page 7).
The power supply cable must be accessible after installing the machine.

Door reversal instructions

Warning! The door stop may only be changed by a specialist. If
necessary,please contact our after-sales service or your specialist dealer.
Warning! Before changing the door stop, disconnect the mains plug;
with a permanent connection: fully unscrew or deactivate the fuse.
1. Open loading door
2. Unscrew hinge A from the front ofthe
machine and take off the loading door.
3. Remove cover plates B and C. To do
this, insert a thin screwdriver into the
slots as shown in the illustration, press
downwards slightly and pry out the
cover plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block D from
the snap-on fixture, take out and reins-
ert on the other side, having rotated the
block through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, reinsert on the
opposite side and screw down.
24
13:16 Page 24
.