Table of Contents
Advertisement
16
Daily use
The programme can no longer be changed directly once the programme has started.
If nevertheless there is an attempt to change the programme on the programme
knob or if an function button (excluding the BUZZER ZOEMER button) is pressed,
led above START PAUSE START PAUZE button starts flashing temporarily in yellow.
The drying programme is not however affected by this (laundry protection).
Putting in extra items or taking items out before end of programme
1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START PAUSE START PAUZE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, END EINDE status led is lighting. If the BUZZER
ZOEMER button has been pressed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles are automatically followed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at intervals during this phase. This keeps the
laundry loose and free of creases. The laundry can be removed at any time during
the anti-crease phase. (The laundry should be taken out towards the end of the
anti-crease phase at the latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best
to use a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF UIT.
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
Hide quick links:
Advertisement
Table of Contents
