Table of Contents
Advertisement
CS7 - RAPID GET YOU GOING INSTRUCTIONS
1.
Assemble and set stem to desired length. (Neatly twist surplus lead around stem close
to the handle, and secure with self securing straps).
2.
Adjust head to correct angle and tighten both head bolt.
3.
Fit batteries and secure battery compartment cover, ensure 'o' ring seal is clean
before replacing cover and forms a visibly good seal all round after screws are
tightened.
4.
Set FREQUENCY to BATT. CHECK position.
5.
Turn detector on by setting THRESHOLD clockwise from OFF position.
6.
Check GREEN battery LED is ON.
7.
Turn FREQUENCY control to mid position.
8.
Adjust THRESHOLD to obtain audio threshold then back off slightly so that no tone is
heard.
9.
You will find all metals within the search head range including some iron and trash
PROVIDING THE SEARCH HEAD IS SLOWLY MOVING OVER THE TARGET
(not stationary).
IF A PROBLEM IS ENCOUNTERED REFER TO THE FULL INSTRUCTIONS.
3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CS7 and is the answer not in the manual?
Questions and answers