CS9000 MK2 - RAPID GET YOU GOING INSTRUCTIONS
Searching for a Metal Object
1.
Turn MODE switch to BATT. CHK and check condition of the battery on meter.
2.
Set THRESHOLD to the centre of the normal band.
3.
Set SIGNAL BALANCE to the centre of the normal band.
4.
Set GROUND BALANCE to the centre of the normal band.
5
Set AUTOMATIC THRESHOLD to No Auto.
6
Turn MODE switch to METAL
7.
Hold detector with arm extended and raise and lower 6 inches. If the sound level does not
change leave the GROUND BALANCE in NORMAL range. If the sound changes
excessively then adjust as described in the section GROUND BALANCE PROCEDURE.
8.
Switch AUTOMATIC THRESHOLD function on and begin search.
Cave or Void Search
1.
Set THRESHOLD to the centre of the normal band.
2.
Set SIGNAL BALANCE to the centre of the normal band.
3.
Set GROUND BALANCE to the centre of the normal band.
4.
Set AUTOMATIC THRESHOLD to on.
5.
Turn MODE switch to BATT. CHK and check condition of battery on meter.
6.
Turn MODE switch to CAVE. Hold the detector with your arm extended and begin to
search, taking care to keep the detector as level as possible and at a constant distance from
the ground.
IF A PROBLEM IS ENCOUNTERED REFER TO THE FULL INSTRUCTIONS.
1
Need help?
Do you have a question about the CS9000 MK2 and is the answer not in the manual?