Controls; Mode Switch - C-SCOPE CS9000 MK2 Operating Instructions Manual

CONTROLS

Mode Switch

PWR OFF
The first position on the MODE switch is the Power Off setting. Be sure the switch is returned to
this position after using the detector. Failure to do so will result in the batteries being discharged.
METAL
In this mode the ground balance is in operation and all metal objects such as gold, silver, coin
caches, iron chests, or even a septic tank lid can be detected. The metal mode will allow the
greatest ground penetration and is the first choice for maximum capability.
CAVE
In this mode the ground balance is non-functional, and the CS9000 MK2 responds to all ground
mineralisation changes. Because voids such as holes or caves have a distinct absence of
mineralisation, the CS9000 MK2 responds by an increase in the sound. Usually ground density
changes are detected as very broad response indications, and will change according to the
operator's position relative to the ground density changes. If the sound decreases of course this
would indicate an increase in mineralisation.
This mode will allow the detection of caves and other voids where treasure might be hidden. The
use of this mode requires a very carefully planned search pattern, paying particular attention to
broad changes in the sound. Marking the sites of each occurrence in a controlled search pattern
will help in the location of these anomalies.
BATT. CHK
This position is used to determine the condition of the batteries which can be read on the meter.
7