Fitting The Hob Into The Worktop - Electrolux 75852 G Instruction Booklet

20

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:
1. place the seals supplied with the hob on the front edge of the cut out.
Then, place them at 86 mm from the side edges and at 10 mm from the
rear edge, as shown in the diagram,
taking care that the seals meet
without overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors
kit (see diagram). When the screws
have been tightened, the excess seal
can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
Seal Seal Seal
Seal Seal