Setting The Speaker Impedance; Turning This Unit On And Off - Yamaha RX-V661 Owner's Manual

Setting the speaker impedance

Caution
If you are to use 6 ohm speakers, set "SP IMP." to
"6 MIN" as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
1
Make sure this unit is turned off.
Refer to the right column for details.
2
Press and hold C
front panel and then press B
OFF inward to the ON position to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
TONE CONTROL
down
3
Rotate the D
front panel to select "SP IMP.".
"SP IMP." and the current speaker impedance setting
("8 MIN") appear in the front panel display.
4
Press C
panel repeatedly to select "6 MIN".
5
Press B
panel to release it outward to the OFF
position to save the new setting and turn off
this unit.
Note
The setting you made is reflected next time you turn on this
unit.
■ Turning on this unit
Press
inward to the ON position to turn on this
unit.
When you turn on this unit by pressing B MASTER ON/
OFF, the main zone is turned on.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
on the
■ Turning off this unit
Press
again to release it outward to the OFF
position to turn off this unit.
MASTER
•
ON OFF
selector on the
• As usual, we recommend using the standby mode to turn off this
■ Set the main zone to the standby mode
on the front
Press
(or
standby mode.
In the standby mode, this unit consumes a small amount of
on the front
power in order to receive infrared signals from the remote
control.
■ Turning on the main zone from the
Press
to turn on the main zone.
y
• You can also turn on the main zone by pressing
• When you turn on this unit, there will be a 4 to 5-second delay
• These buttons are operational only when

Turning this unit on and off

B
B
Notes
A
MAIN ZONE ON/OFF on the front panel as well as
POWER and STANDBY on the remote control are
B
operational only when MASTER ON/OFF is pressed
inward to the ON position.
unit.
A
STANDBY) to set the main zone to the
standby mode
A
SCENE) buttons.
before this unit can reproduce sound.
OFF is pressed inward to the ON position.
Connections
on the front panel
on the front panel
(or )
F
SCENE (or
B
MASTER ON/
25
En