Table of Contents
Advertisement
Optimizing the speaker setting for your listening room
This unit performs the following checks:
Speaker wiring WIRING
Checks which speakers are connected and the
polarity of each speaker.
Speaker size SIZE
Checks the frequency response of each speaker and
sets the appropriate low-frequency crossover for each
channel.
Speaker distance DISTANCE
Checks the distance of each speaker from the
listening position and adjusts the timing of each
channel.
Equalizing EQUALIZING
Checks and adjusts the tonal characteristics of all the
speakers by the setting of "EQ".
Speaker level LEVEL
Checks and adjusts the volume level of each speaker.
The display changes as follows.
AUTO:MENU
EXTRA SP ASSIGN
ZONE2 >FRONT B
PRESENCE
SETUP;;;;;;;AUTO
EQ;;;;;;;NATURAL
. START
[ ]/[ ]:Up/Down
[
[
[ ]/[ ]:Select
AUTO:CHECK
INITIALIZING
. WIRING
SIZE/DISTANCE
EQUALIZING
LEVEL
CHECK CH=CENTER
|||||;;;;;;;;
[ ]:Exit
AUTO:RESULT
. RESULT
SP
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
SET
>
[ ]/[ ]:Up/Down
[ENTER]:Enter
30
En
NONE
:
3/4/0.1
CANCEL
The results displayed under "RESULT" are as
follows.
Number of speakers SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance DIST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LVL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
Notes
• If "E-10:INTERNAL ERROR" appears during the testing
procedure, restart from step 4.
• If you selected "RELOAD" in step 4, no test tones are
output.
• If an error occurs during the "AUTO:CHECK" procedure,
the setup procedure is canceled and an error screen
appears. For details, see "If an error screen appears" on
page 32.
• When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" and the
number of warning messages appears in the above of
"RESULT" (see page 32).
• Depending on the listening environment, "SWFR
PHASE:REV" appears during the "AUTO:CHECK"
procedure and "SUBWOOFER PHASE" in "SOUND
MENU" (see page 72) is automatically set to
"REVERSE".
8
Press
to display the setup results
in detail.
AUTO:RESULT
. RESULT
SP
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
>
SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
RESULT:WIRING
FRONT L;;;;;;;OK
[
[ ]/[ ]:Select
[ENTER]:Return
:
3/4/0.1
CANCEL
[
Advertisement
Table of Contents
