Installation Instructions - Blaupunkt San Andres 970 Operating Instructions Manual

(including add RF power amplifier), add external antenna or use other transmit antennas;

Please do not make interference to legitimate radio communication services during the using
of product. Once the interference occurs, user should immediately stop using the product and
the product should not be used unless the interference is disappeared;
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:

(1) this device may not cause harmful interference,

(2) this device must accept any interference received, including interference that may cau
se undesired,operation.

Installation Instructions


The vehicle must meet the voltage, current and power that required, please check the
conditions before installation;

The installation should be done while the battery of the vehicle is disconnected;

To ensure that the product has been fitted with a fuse;

The installation of the product should not affect the safety of the operation and
function of the vehicle;

The installation position should not block the driver's sight and should not be on the place
that the brake, steering wheel, seat belts, airbags and other vehicle safety equipment should
be;

Please confirm the matching condition of the vehicle interface before install this product,
use the appropriate patch plug if the interface is not matched;

Please be familiar with the connection of the vehicle before installation, confirm the
position of the piping, electrical wiring, fuel tank and other vehicle system components. Do not
touch or damage these components and avoid the exposure of wires that may cause
corrosion, leakage, etc.;

Please do not conduct the installation in place of condensation, drench water sites, high
humidity, containing dust and oil smoke. If water, moisture, dust and oil smoke enter the product,
it may cause smoke, fire or failure;

Please do not move or disassembled the existing screws, nuts, bolts, clips, connecting
fixed appliances, accessories and so on, do not change or remove vehicle incidental contact
system and wire clip, otherwise it may impair the function of automobile safety;

In order to avoid the occurrence of fire damage to the product or vehicle, please do not
allow the existing power supply circuit overload when power the product; Please be sure
that the power wires have insulation treatment and install with fuses, circuit breakers and
relays;

Please use non conductive tape in insulation treatment, wrap the ends of the wire and
unused wire; correct insulating treatment can avoid the occurrence of electric arc, electric
shock or fire. In order not to impede the brake pedal, gearbox and steering wheel, plastic belt
could be used to fix the wires. Please do not make the wires contact high temperature surface,
the heat can easily cause damage to the wires and lead to short circuit, arc or fire;

Please fix the wire on the electric chair or other parts of vehicle where will not lead to
the scratch or damage of wire. In addition, the wire should be fixed in the hidden place as
far as possible, it will make the environment inside the vehicle beautiful;

Please do not block the airflow vents, otherwise it may cause internal overheat and fire;
2