Table of Contents
Advertisement
Electrical connection
The unit is preset to work with a voltage of single phase
230 V.
Before making the connection make sure that:
— the energy power available in the user's house is
sufficient for the normal supply of this appliance (see
rating plate).
— the unit is correctly connected to earth through a
suitable plug and according to the installation country
Laws.
— the socket or the omnipolar switch used for the
connection must be easilv reached with the installed
appliance.
The appliance is supplied with electric cable, therefore
you will have to fit it with a standard plug, suitable for the
total electric load shown on the rating plate. The plug is
to be inserted into a suitable wall socket.
If you wish to directly connect to the mains, you have to
interpose an omnipolar switch with a minimum opening
between contacts of 3 mm, between the unit and the
mains, complying with the existing regulations. The
brown live wire (originating from the clamp of the
appliance junction box) must always be connected to the
phase of the mains supply. In any case, the supply cord
must be positioned in such a way as it doesn't reach in
any point a temperature higher by 50°C than the room
temperature.
Replacement of the electric
cable
Should the supply cord need to be replaced, use only
the following cable types: H07 RN-F, H05 RN-F, H05 RR-
F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F. It is
necessary that the yellow/green earth wire is about 2 cm
longer than the live and neutral ones (Fig. 19). After the
connection, test the heating elements for about 3
minutes to ensure that they are working correctly.
The manufacturer refuses any responsability in
cases where normal safety measures are not
observed.
26
Phase
Ground (yellow - green)
Neutral
wire
Fig. 19
Advertisement
Table of Contents
