ProForm 635 User Manual page 7

4. Insert a Handrail Extension (85) into the post on the left
Upright (82). If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Align the holes in the
Handrail Extension with the holes in the post. Next, at-
tach the Handrail Extension by tightening three Short
Screws (76) into the indicated holes. Note that the hole in
the left side of the post is not used. Note: If there is only
one hole in the top of the post, tighten the third Short
Screw into the hole in the left side of the post.
Identify the Left Handgrip (122), which has a large cutout
in the right side. Slide the Left Handgrip as far as possi-
ble onto the Handrail Extension (85). It may be helpful to
apply soapy water to the Handrail Extension.
5. Make sure that the front edge of the Left Handgrip (122)
is under the Console Base (87) as shown. Tighten a
Short Screw (76) into the side of the Left Handgrip as
shown.
Attach the other Handrail Extension (not shown) and the
Right Handgrip (not shown) as described in step 4 and
this step.
Note: When assembly is completed, there may be
extra screws left over.
6. Refer to drawing 6a. Locate the left Rear Foot (59) on
the treadmill. If the left Rear Foot touches the floor, go to
step 7. If there is a space between the left Rear Foot and
the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page 22.
Refer to drawing 6b. Using a phillips screwdriver, remove
the Rear Foot Screw (60), the right Rear Foot (59), and
the Rear Foot Spacer (120) from the treadmill. Reattach
the right Rear Foot without the Rear Foot Spacer. Hold
the treadmill with both hands, and lower the treadmill as
described on page 22.
Check the left Rear Foot (59 [see drawing 6a]). If the left
Rear Foot is still off the floor, raise the treadmill and re-
move the left Rear Foot. Snap the Rear Foot Spacer
(120) onto the left Rear Foot and reattach the left Rear
Foot and the Rear Foot Spacer. Carefully lower the
treadmill.
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet
from damage, place a mat under the treadmill.
4
85
122
Cutout
5
76
122
6a
59
6b
60
59
120
Post
76
76
82
76
87
76
7