ProForm 635 User Manual page 15

Enter your age.
4
When a pulse pro-
gram is selected, the
letters "AGE" will ap-
pear in the Calories/
Watts/Pulse display.
You must enter your
age to use a pulse program. If you have not en-
tered your age, press the Incline buttons to enter
your age. Once you have entered your age,
your age will be saved in memory.
Press the Start button or the Speed
5
start the program.
A moment after the button is pressed, the walking
belt will begin to move. Hold the handrails and
begin walking.
Each pulse program is
divided into twenty-
three, one-minute seg-
ments. One heart rate
setting is programmed
for each segment. The
heart rate setting for
the first segment will
be shown in the flash-
ing Current Segment column of the LED display.
The heart rate settings for the next seven seg-
ments will be shown in the seven columns to the
right.
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash, a se-
ries of tones will sound, and all heart rate settings
will move one column to the left. The heart rate
setting for the second segment will then be shown
in the flashing Current Segment column and the
speed and/or incline of the treadmill will automati-
cally change to bring your heart rate closer to the
heart rate setting for the second segment.
button to
Current Segment
If your heart rate is not detected during the pro-
gram, the Calories/Watts/Pulse display will be
blank. (See HEART RATE MONITOR TROUBLE-
SHOOTING on page 8.) The speed and/or incline
of the treadmill may also decrease until your heart
rate is detected.
The program will continue until the heart rate set-
ting for the last segment is shown in the Current
Segment column and the Time/Segment Time
display counts down to zero. The walking belt will
then slow to a stop.
Whilst the program is in progress, minor adjust-
ments can be made to the speed or incline of the
treadmill with the Speed or Incline buttons.
However, if you increase the speed, the incline
will automatically decrease; if you decrease the
speed, the incline will increase. If you increase the
incline, the speed will decrease; if you decrease
the incline, the speed will increase. The console
will always attempt to keep your heart rate near
the heart rate setting for the current segment.
Note: When the incline reaches the lowest setting,
the speed cannot be increased any further. When
the incline reaches the highest setting, the speed
cannot be decreased any further.
Pulse programs should not be stopped temporar-
ily and then restarted. However, pulse programs
can be stopped at any time with the Stop button.
To reuse a pulse program, reselect the program
and then restart it at the beginning.
Follow your progress with the displays.
6
Refer to step 6 on page 11.
When the program has ended, remove the key
7
from the console.
See step 7 on page 14.
15