Pro-Form 625 Treadmill User Manual page 7

4. With the help of a second person, carefully tip the
Uprights (82, 122 [not shown]) to the vertical position.
Feed the Wire Harness (34) through the indicated hole
near the top of the Right Upright (82).
Hold the Pulse Bar (109) near the Right Upright (82).
Feed the wire in the Pulse Bar into the hole in the side of
the Upright and out of the hole near the top of the Upright.
Insert the tabs on the end of the Pulse Bar into the Right
Upright. If necessary, pull back the foam on the Pulse
Bar. Orient the Pulse Bar with the pulse sensors on top
as shown. Attach the Pulse Bar between the Uprights
with two 3 1/2" Bolts (107). Do not to pinch the wires.
5. Attach the Latch Assembly (9) and the Latch Spacer (56)
to the Left Upright (122) with two 3/4" Tek Screws (101)
as shown.
6. Insert a Handrail Extension (85) into the post on the Left
Upright (122). Align the holes in the Handrail Extension
with the holes in the post. If necessary, tap the Handrail
Extension with a rubber mallet to fully insert it. Next, attach
the Handrail Extension by tightening three 1/2" Tek
Screws (76) into the indicated holes. Note: If there is
only one hole in the top of the post, tighten the third
Screw into the hole in the left side of the post.
Identify the Left Foam Grip (110), which has a large cutout
in the right side. Slide the Left Foam Grip as far as possi-
ble onto the post on the Left Upright (122). It may be help-
ful to apply soapy water to the Handrail Extension (85).
7. Tighten a 1/2" Tek Screw (76) into the side of the Left
Foam Grip (110) as shown. Note: You may need to pull
on the side of the Left Foam Grip to align the screw hole
with the hole in the Left Upright (122).
Attach the Right Foam Grip (not shown) and the other
Handrail Extension (not shown) as described in step 6
and this step.
4
109
5
56
6
110
7
7
34
Wire
Hole
107
82
9
122
101
Post
76
85
76
122
Cutout
76
110
122