Pro-Form 6.0 Rt Treadmill Manual page 9
English manual
Hide thumbs
Also See for 6.0 Rt Treadmill:
- User manual (28 pages) ,
- User manual (28 pages) ,
- User manual (28 pages)
Table of Contents
Advertisement
3. Locate the Upright Wire (63) bundled between
the Base (74) and the Belly Pan (52). Remove
all ties securing the Upright Wire. Route the
Upright Wire into the Base and out of the indi-
cated hole.
Press a Base Cap (70) into each side of the
Base (74).
See the inset drawing. Cut the plastic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire.
4. Identify the Right Upright (33). Have a second
person hold the Right Upright near the
Base (74).
See the inset drawing. Tie the wire tie in the
Right Upright (33) securely around the end of
the Upright Wire (63). Then, insert the Upright
Wire into the lower end of the Right Upright as
you pull the other end of the wire tie through the
Right Upright.
3
52
63
Hole
4
33
63
Wire Tie
74
9
74
Tie
Ties
Cut
70
63
63
Wire
Tie
33
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 6.0 Rt Treadmill and is the answer not in the manual?
Questions and answers
the track is stuck in an incline position and the display continues to move through the various speed settings but none of the buttons can be activated. to lower the tack or start and stop any function. while in a programed mode I increased and lowered thespeed and now nothing works
To fix a stuck incline on a Pro-Form 6.0 RT Treadmill when the display is unresponsive, follow these steps:
1. Hold down the Stop button and the Speed increase button.
2. Insert the key into the console.
3. Release the Stop button and the Speed increase button.
4. Press the Stop button again.
5. Press the Incline increase or decrease button.
The treadmill will automatically rise to the maximum incline level and then return to the minimum level to recalibrate the incline system. If the incline does not begin calibrating, repeat steps 4 and 5. Once the calibration is complete, remove the key.
This answer is automatically generated
Does Proform 6.0 RT model require user to lubricate the motor belt?