Wash Cycle Button; Production Button; Notes On Pre-Cooling System - Hommy Soft Ice Cream Machine User Manual

again automatically every 120 minutes while the hopper pre-cooling system is regulated by the
pre-set temperature.
c. In programming mode, press the pre-cooling button to select the function to be programmed –
calibration of the ice cream hardness level [value between 30 and 100] or press again to set the
pre-cooling temperature or press again to set the current value).

Notes on pre-cooling system:

This machine is equipped with a pre-cooling and a freshness preservation system. The pre-cooling
system operates in the hoppers through a combination of an independent refrigeration system and a
mixer motor which ensures that temperature is maintained evenly. This system has the dual advantage
of speeding up ice cream production and preserving the quality of the mixture.
The freshness preservation system works by combining the preservation quality of the pre-cooling
system with a preservation function in the freezing cylinders. This enables the mixture in both the
hoppers and cylinders to be preserved through the application of low temperature during periods in
which the machine is idle.

7.3.3) Wash cycle button

a. In stand-by mode, press the wash button
become blue. To stop the wash function, press the wash button again. Alternatively, the wash
function stops automatically after 5 minutes. During the wash process, the beater motors will work
without the refrigeration function, thus protecting the machine.
b. In programming mode，this button is pressed in order to decrease the value of the function being
programmed. For example, if the hardness setting is being calibrated, pressing the wash button (-)
will decrease the value of the calibration.

7.3.4) Production button

a. Press the production button (M)
will light with a blue backlight and simultaneously display window E will indicate the
production motors are in action
automatically and display window E will indicate production progress (1%~100%). Press the
production button again to stop production.
b. In programming mode，this button is pressed in order to increase the value of the function being
programmed. For example, if the hardness setting is being calibrated, pressing the production (+)
26,40
to wash the machine. The wash indicator
to start production situation. The production indicator (A)
H o m m y
. After some seconds, the compressor will start
will