6. Cleaning Procedure
6.1) Pre-production cleaning
a. Remove the throat block by unscrewing the four nuts.
b. Use household detergent or a chlorine solution to clean the hoppers, freezing cylinders, beater
sticks, inlet tube and face block. Dip the throat block in the cleaning solution and pull the draw
handles three or four times. Thereafter remove the throat block horizontal bar and release the
three draw valves. Ensure all components are thoroughly cleaned. Before re-assembly, lightly
spread edible oil on all rubber O rings to ensure easy operation and to prevent wear and tear.
Re-assemble in reverse order
19,40
Step 1: Remove tightening nuts
Step 2: Pull draw handles 2 or 3 times in cleaning solution
Step 3: Remove cross-bar stopper