Unpacking; Assembly - GMC RBS10 Instruction Manual

Unpacking

Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.

Assembly

The Band Saw is shipped partly disassembled and the saw
table and rip fence guide have to be installed prior to use.
1. Remove the rip fence scale from the table.
2. Place the table onto the table trunnion.
3. Fix the table to the trunnion using the 4 hex head
bolts and serrated lock washers.
4. Place the table insert into the hole in the centre of the
table.
5. Replace the rip fence scale on the table.
6. Adjust the distance between the rip fence guides by
raising the rip fence guide handle to unlock it and
turning the handle. The distance between the guides
needs to be long enough to enable the fence to fit over
the table.
7. Position the fence on the table with the guides located
in the channels either side of the table.
8. Slide the fence to the desired location and push the rip
fence guide handle down to lock the fence in position.
9. If required, assemble the support stand and attach the
band saw to this stand.
1
2
3
4
5
6
6
7
8
9