Operation; Maintenance - GMC RBS10 Instruction Manual

Operation

Switching on and off
1. Connect the plug to the power supply.
2. Depress the ON button.
3. To switch off, depress the OFF button.
NOTE.
1. The saw must be connected to an earthed outlet and
should be operated on a residual current device (RCD)
of 30 mA capacity.
2. Extension leads must have a minimum lead cross
section of 3 x 0.75 mm (240V).
3. The saw is automatically turned off in the event of a
power failure. You will need to press the ON button
again to restart the saw (only on some models).
Using the rip fence
The rip fence allows you to make parallel cuts in a sheet
of wood, all at the same width.
WARNING. Always ensure that the saw is switched off
and unplugged from the power supply before making any
adjustments.
1. Adjust the rip fence to the required width and secure it
in position with the locking handle.
2. Ensure that the fence rests against the wood along its
entire length to give a consistent parallel cut.
Cutting
NOTES.
1. Use only enough pressure to keep the saw cutting.
Do not force the cutting.
Allow the blade and the saw
to do the work.
2. When cutting at an angle
ensure that the rip fence is
located on the right hand side
of the blade.
3. When cutting rod, use a jig
or fixture to prevent the
workpiece from turning.
4. When cutting boards vertically,
use a suitable push block to
feed the workpiece into the
saw.

Maintenance

Cleaning
Note. Always wear eye protection when cleaning the tool.
1. Keep the tool's air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.
General inspection
1. Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
Repairs
Call GMC on 1300 880 001
We can advise you as to the best method to repair
your tool.
Please do not return the tool to the store where you
purchased it without first contacting GMC.
10