Table of Contents
Advertisement
Maintenance and cleaning
caution
• B efore maintenance or cleaning is carried out,
the rangehood should be disconnected from the
main power supply. Ensure that the rangehood is
switched off at the wall socket
and the plug removed.
• E xternal surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
Glass Surfaces
Glass surfaces are best cleaned immediately after soiling
using warm soapy water.
Use a dry soft cloth to remove any excessive moisture left
after cleaning.
Do not use harsh abrasive cleaners or metal scrapers
Stainless Steel Surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Control panel surface
The control panel can be cleaned using warm soapy water.
Ensure the cloth is well wrung before cleaning. Use a dry
soft cloth to remove any excess moisture left after cleaning.
Use the "lock" button before cleaning the control panel.
Cleaning grease filters
The filters can be cleaned by hand or dishwasher in warm
soapy water.
By hand
– S oak in warm water and some
washing up liquid. For stubborn grease
stains use a soft nylon brush to help
remove these stains. After cleaning
ensure that the filters are completely
dry before refitting.
In a dishwasher – E nsure that placement of the filters is
made so as to not impede the function
of the spray arm. Filters should be
washed separately to crockery and
other kitchen utensils. After cleaning
ensure that the filters are completely
dry before refitting.
electrolux canopy rangehood maintenance and cleaning 7
Changing the halogen lamps
Ensure lamp is cool before removing.
Using a small flat blade screw driver remove the inner
stainless steel ring to obtain access to the halogen globe.
When removing the inner ring, do so carefully, as the glass
lense could easily fall out of the inner ring. Remove the
halogen globe, whilst cool, and replace carefully with a
new globe.
The rangehood takes 2 x 20W, 12 volt halogen globes
important
When handling globes hold with a cloth or gloves to ensure
perspiration does not come into contact with a globe as this
can reduce the life of the globe.
Removing carbon filter
Open the glass door to the "Service" position. Remove
the oil cup (as shown on page 8) Remove the baffle filter
(as shown on page 9) Disengage the bottom carbon filter
left and right hooks (see Fig 1) Disengage the top carbon
filter left and right hooks (see Fig 2).
Fitting carbon filter is the reverse of above procedure
Fig 1. Pull bottom hook
down and pull toward
you to disengage
Fig 2. (Top hooks,
left and right sides)
Fig 1. (Bottom hooks,
left and right sides)
Fig 2. Lift top hook and pull
toward you to disengage
Advertisement
Table of Contents
