Table of Contents
Advertisement
Using the rangehood –
low
medium
Touch screen operation
Lock – Depress and hold 'lock' button for 3 seconds to lock
control interface when cleaning, touch and hold for 3 seconds
to unlock control interface.
Fan – select speed to suit cooking conditions.
Low – light frying/boiling
Medium – frying/wok cooking/heavy boiling
High – grilling, intensive frying and wok cooking
Boost – increases air extraction when intense cooking &
frying is taking place, which is generally over a short time
frame when searing foods. On selecting the boost function
the fan intensity will increase for 1 minute, then revert back
to the last selected fan speed.
To switch Lights ON and OFF
Depress the 'light' button to turn the lights ON and depress
'light' button again to turn the lights OFF.
Using the Timer
At the end of cooking if the timer is switched on, the
rangehood will continue to run for an additional 5 minutes
to remove any odours that remain at the completion of
cooking. After 5 minutes the canopy will turn itself OFF.
Depress 'auto off' button to turn the timer ON and depress
'auto off' button again to cancel the timer function.
Maintenance and cleaning
caution
• B efore maintenance or cleaning is carried out,
the canopy rangehood should be disconnected
from the main power supply. Ensure that the
rangehood is switched off at the wall socket
and the plug removed.
• E xternal surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
electrolux e:line rangehood maintenance and cleaning/changing the halogen lamps 5
ERCE9020AS
OFF
high
light
auto off
Stainless Steel Surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
boost
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Control panel surface
The inlay control panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning. Use
a dry soft cloth to remove any excess moisture left after
cleaning.
Cleaning grease filters
The mesh filters can be cleaned either by hand or in
the dishwasher. After cleaning ensure that the filters are
completely dry before refitting.
By hand: Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains.
In a dishwasher: Ensure that placement of the filters
is made so as to not impede the function of the spray
arm. Washing the filters in a dishwasher may cause
discolouration of the aluminium inner mesh over time
although it will not affect their performance. Filters should
be washed separately to crockery and kitchen utensils.
Changing the halogen lamps
Using a small flat blade screwdriver remove the inner
stainless steel ring to obtain access to the halogen globe.
When removing the inner ring, do so carefully, as the glass
lens could easily fall out of the inner ring. Remove halogen
globe, whilst cool, and replace carefully with a new globe.
The rangehood takes 2 x 20W, 12 volt halogen globes.
important
When handling globes hold with a cloth or gloves to ensure
perspiration does not come in contact with the globe as this
can reduce the life of the globe.
Advertisement
Table of Contents
