Bowens ESTIME 3000 Operating Instrctions page 3

Key To Figure 1
1. Flash Head Sockets (3)
2. Channel Power/Light Output Indicators (3)
3. Spare Fuses-in Carry Handle (2)
4. Power/Light Output Selector Chart
5. Photocell Slave
6. Standard 6.5mm 'jack' Sync. Socket
7. U.S.A Style 3 Blade Sync. Socket
8. Charge Rate-Hare(Normal)/Tortoise(Slow)
9. Supply (A.C.) Input Socket
10. Supply (A.C.) On/Off Switch
11. Fuse-Modelling Light
12. Fuse-Flash
13. Photocell (Slave) On/Off Button
14. Audio Sounder (Ready) On/Off Button
15. Open Flash (Test) Button
16. Modelling Light On/Off Button
17. Modelling Continuous/Intermittent Button
18. Modelling Full/Ratio Button
19. Carry Handle (Contains Spare Fuse)
20. Individual Channel Output Up Button (QTY 3)
21. Individual Channel Output Down Button (QTY 3)
22. Combined (Ratio) Up Button
23. Combined (Ratio) Down Button
24. Coded Infra Red Receiver
25. Coded Infra Red Channel Number
26. Coded Infra Red Channel Selector Button
27. D.C.-Switched Mode Power Supply Socket
28. Miniature 3.5mm 'jack' Sync Socket for Automatic Multiple Fire (AMF) system
29. AMF Test Button
ATTENTION
The re-chargeable memory battery may be in a discharged state when the
generator is new or has not been used for some time.
Operating the generator for at least one hour should provide up to 24 hours of
memory. Longer periods of use enable the battery to be fully charged which can
extend the memory period up to 4 weeks.
If the channel indicators do not operate correctly when first switched on, this may
indicate that the battery is in a discharged state. To reset the indicators use the
channel up/down buttons on the ESTIME 3000 SC or the 'all up' or 'all down'
buttons on the ESTIME 3000 AMF until normal operation is obtained.
(See Memory section of operating instructions).
- 3 -