Remote Control - Bowens ESTIME 3000 Operating Instrctions

Switch Mode Operating Parameters
FUNCTION
CHARGE TIME TO FULL POWER
MINIMUM NUMBER OF FLASHES
FROM FULLY CHARGED 12 VOLT CAR
BATTERY TYPICAL 25 AMP/HOUR
FLASHES AT FULL POWER/MINIMUM
INTERVALS TO SWITCHED MODE
MODULE OVERHEAT
NOTE: THE CAR ENGINE MAY BE RUN TO RECHARGE THE BATTERY,
WHILE THE SWITCHED MODE POWER SUPPLY IS CONNECTED, AS
REQUIRED.
13. Remote Control - ESTIME 3000 AMF ONLY
I.R. Receiver
Code (Channel)
No. Window
Code (Channel)
Selector Button
I.R.
REMOTE
CODE No
FIG 5
- 18 -
3000 AMF
12 SECS.
100+
75
The ESTIME 3000 AMF has a
built in infrared remote control
receiver. By using the Remote
Control Transmitter accessory,
(BW-2905), up to six Generators
can be individually or collectively
controlled. All of the Generator
panel controls are duplicated on
the remote control transmitter.
To select the Generator receiver
channel (code) number
repeatedly press and release the
channel selector button until the
required number appears in the
channel number window (Figure
5). The channel number window
will go blank between channel
numbers 6 & 1 and in this
condition the remote control
receiver is 'OFF'.