How To Wire Your Ceiling Fan - Emerson CF760AB00 Owner's Manual

BP7287 60" DESIGNER FAN

How to Wire Your Ceiling Fan

If you feel that you do not have enough
electrical wiring
experience, have your fan installed by a
licensed electrician.
WARNING
!
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before wiring.
NOTE: If you are not sure if the outlet box
is grounded, contact
electrician for advice, as it must be
grounded for safe operation.
1. Connect the green grounding lead from
the hanger ball
grounding lead from the hanger bracket
to the grounding conductor of supply
(this may be a bare wire or wire with
green colored insulation). Securely
connect wires with wire connectors
supplied.
BLACK AND BLUE
GROUND
FAN WIRES
WIRE
LISTED
WIRE
CONNECTOR
(3)
GREEN WIRE
(GROUND)
FROM
HANGER
BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
Figure 12
NOTE: If you are using an Emerson
Light Fixture with your fan, see Light
Fixture Owner's Manual for wiring.
2. Securely connect the fan motor white
wire to the supply white (neutral) wire
using wire connector supplied (Figure
12). Securely connect the fan motor
black wire and blue wire to the supply
black (hot) wire using wire connector
supplied (Figure 12). After connections
have been made, turn leads upward
and carefully push leads into the outlet
box, with the white and green leads on
one side of the outlet box and the black
and blue leads on the other side of the
outlet box.
3/10/05 10:42 AM Page 7
knowledge or
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
3. Screw
(supplied) into the tapped holes in the
hanger bracket.
a licensed
4. Lift the ceiling cover up to the threaded
studs and turn until studs protrude
through the holes in the ceiling cover
(Figure 13).
and the green
5. Secure the ceiling cover in place by
sliding lockwashers over the threaded
studs and installing the two knurled
knobs (supplied). (Figure 13). Tighten
the knurled knobs securely until the
ceiling cover fits snugly against the
ceiling and the hole in the ceiling cover
is clear of the downrod. Your fan is now
wired to be turned on and off from the
fan switch.
WHITE
SUPPLY
(NEUTRAL)
THREADED
STUD (2)
WHITE FAN
WIRE
BLACK
SUPPLY
KNURLED KNOBS (2)
(HOT)
Figure 13
NOTE: CEILING COVER
OMITTED FOR CLARITY.
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and not
pinched between the ceiling cover and
the ceiling.
6. Cut the 3-speed switch pull chain to a
desired length (optional). Connect the
wood pendant (supplied) to the 3-
speed switch pull chain by sliding the
wooden pendant (small hole first) onto
the pull chain. Attach the chain coupling
to the end of the chain and allow the
wooden pendant to fall down over the
coupling.
7
WARNING
!
the two threaded studs
CEILING
COVER
LOCKWASHER
WARNING
!