How To Wire Your Ceiling Fan - Emerson KF200NI00 Owner's Manual

Emerson Structures 1/24/05
How to Wire
Your Ceiling Fan
If you feel that you do not have enough
electrical wiring knowledge or experi-
ence, have your fan installed by a
licensed electrician.
WARNING
!
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned
off at the main fuse box before
wiring. All wiring must be in accor-
dance with National and Local codes
and the ceiling fan must be properly
grounded as a precaution against
possible electrical shock.
CAUTION: To reduce the risk of electri-
cal shock, disconnect the electrical
supply circuit before installing the fan,
light kit or receiver.
1. Position the supply wires to the left side
of the outlet box (Figure 16); position
the fan wires to the right side. Partially
insert the remote control receiver (flat
side up) until one end rests on the
hanger ball as shown in Figure 16.
NOTE: Make all wiring connections
using wire connectors (supplied). Make
sure that all connections are tight,
SUPPLY WHITE WIRE
(NEUTRAL)
SUPPLY BLACK
WIRE (HOT)
GROUND WIRE
GREEN GROUND
WIRE FROM
HANGER BALL
ANTENNA
GREEN GROUND
WIRE FROM
HANGER BRACKET
1-1/4" THREADED
STUD (2)
Figure 16
8:22 AM Page 10
including ground, and that no bare wire
is visible at the wire connectors, except
for the ground wire.
2. Refer to Figure 16 and 17 and connect
the receiver wires to the supply wires
and the fan motor wires as follows:
a. Securely connect the green grounding
wires from the hanger ball and the
hanger bracket to the supply grounding
conductor (this may be a bare wire or a
wire with green insulation).
b. Securely connect the supply white
(neutral) wire to the receiver white
(AC IN N) wire.
c. Securely connect the supply black wire
(hot) wire to the receiver black (AC IN
L) wire.
d. Securely connect the fan motor white
wire to the receiver white (TO MOTOR
N) wire.
e. Securely connect the fan motor black
wire to the receiver red (TO MOTOR L)
wire.
f. Securely connect the fan motor blue
wire to the receiver blue (FOR
LIGHT) wire.
!
Check to see that all connections are
tight, including ground, and that no
bare wire is visible at the wire con-
nectors, except for the ground wire.
Do not operate fan until blades are in
place. Noise and fan damage could
result.
RECEIVER WHITE
WIRE
RECEIVER
BLACK WIRE
FAN
BLACK
WIRE
FAN BLUE WIRE
FAN WHITE WIRE
RECEIVER WHITE WIRE
10
WARNING
RECEIVER RED WIRE
RECEIVER BLUE
WIRE