Operation - GMC 18VDT18V Instruction Manual

If you wish to charge a second battery pack, pull out the
plug from the mains supply and keep it disconnected for
at least 15 minutes before attempting to charge the
second battery.
To obtain the best life for the battery
Never allow the truck to come to a complete stand still
before recharging the battery. The battery should be placed
on charge whenever the battery is noticeably running down
or the truck no longer performs as it previously performed.
Avoid conducting short charges. Make sure that the battery
is fully charged every time by allowing the charger to
complete its full charging cycle.
Avoid allowing lose items like screws or nails etc to be
stored with battery packs as these or similar items can short
battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in a
dry secure place.
Avoid charging or storing your battery in temperatures below
0ºC and above 40ºC.
Installing the battery into the remote control
IMPORTANT. Only use an alkaline 9V battery in
this transmitter.
1. Remove the screw of the
battery cover on the back of
the remote control by turning
it anti- clockwise using a small
Philips head screwdriver (not
included).
2. Slide the battery cover off the
remote control.
3. Press the battery into the
battery cavity.
Note. Ensure the terminals of the
battery line up with the terminals
inside the remote control.
IMPORTANT: Ensure the '+'
battery terminal is contacting the
'+' terminal inside the remote
control. See diagram inside
remote control for proper battery
orientation.
4. Reinstall battery cover.

Operation

Truck ON/OFF switch
To switch the truck ON, move the
switch (3) located on the bottom
of the truck forward. To turn
the truck OFF, slide the switch
backwards.
Controlling the truck
WARNING. Ensure the truck is being operated in a safe
environment free from motor vehicles and pedestrians.
10