What To Do If - AEG BS7304001 User Manual

28

What to do if...

Removing and cleaning the door glass panels
1. Remove the oven door.
2. Hold the door trim (B) on the top edge of
the door at the two sides and push in-
wards to release the clip seal.
3. Pull the door trim to the front to remove
it.
4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The appliance does not heat up
The oven lamp does not oper-
ate
Possible cause
The appliance is deactivated
The time of day is not set
The necessary settings are not
set
The automatic switch-off is ac-
tivated
The fuse is released
The oven lamp is defective
B
Solution
Activate the appliance
Set the clock. Refer to "First
setting the time of day"
Make sure, the settings are cor-
rect
Refer to „Automatic switch-
off"
Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
Replace the oven lamp.