Using The Map Display; Repeat The Last Voice Prompt; Changing The Announcement Volume; Map Zooming - Becker TRAFFIC ASSIST Z101 Operating Instructions Manual

>>> NAVIGATIONAL MODE

Using the map display

> D

Repeat the last voice prompt

> GB During route guidance, the system an-
nounces important information, e.g. the
> F
next driving manoeuvre. The last an-
nouncement can be repeated with updat-
> I
ed information.
> E
> NL
> Press the preview area while route guid-
ance is active and the toolbar deactivat-
ed.
The last announcement is repeated with
updated information. The volume is also
displayed.

Changing the announcement volume

The volume of announcements can be
adjusted.
54
> Press the preview area while route
guidance is active and the toolbar
deactivated.
The bar display indicates the volume.
> Press
or to increase or
decrease the volume.
> Press in order to mute the
announcements.
> Press
again in order to cancel the
mute function.
!Warning
Always adjust the volume so that you
can still hear any ambient noise while
driving.
The bar display disappears again automat-
ically after three seconds if no button is
pressed.

Map zooming

The map can be zoomed into in steps via
the zoom buttons.
Note:
The zoom buttons are only visible, if you
switch off the function
Autozoom
scribed under "The Map options button"
on page 57.
> Press zoom in to "zoom in on the
map" and therefore to get closer to the
details displayed.
> Press zoom out
to "zoom out from
the map" and therefore to obtain a larg-
er overview.
de-