Replacing The Oven Light; Grease Filter - Electrolux EOB 6730 Instruction Booklet

The Hinged Grill
Some models are fitted with a hinged grill element, to
enable you to clean the roof of the oven easily.
Before proceeding ensure the oven is cool
and is isolated from the electricity supply.
Undo the screws which hold the grill in place (see
"
diagram). When doing this operation for the first time,
we recommend using a screwdriver.
Then gently pull the grill downward to allow access to
"
the oven roof.
Clean the oven roof with a suitable cleaner and wipe
"
dry before replacing the hinged grill element.
Gently push up the grill element into place and firmly
"
screw into place the holding nuts.
Ensure the grill holding nuts are firmly in place
to avoid the grill falling down when in use.

Replacing the Oven Light

Disconnect the appliance from the power
supply.
If the oven bulb needs replacing, it must comply with the
following specifications:
- Wattage power: 27 W,
- Voltage: 240 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service Force
Centre.
!
To replace the faulty bulb:
1. Ensure the oven is disconnected from the
electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.

Grease Filter

Disconnect the appliance from the power
supply before fitting/removing the grease
filter.
When cooking meat, the grease filter must be fitted over
the oven fan by clipping it over the vents in the back
panel. This will prevent a built-up of fat on the fan impellor.
Do not use abrasive materials to clean the seal. The
grease filter is dishwasher proof.
When cooking is completed and the oven has cooled
down, remove the filter by pushing the protruding tongue
on the filter upward (see diagram).
Wash the filter after use using warm soapy water.
Fit the grease filter only when roasting.
1 8