Table of Contents
Advertisement
Clean the oven door glass with warm water and a softh
cloth only. Never use harsh abrasives as they could
damage the special heat-resistant surface of the inner
glasses. Once the cleaning is carried out, refit the oven
door, following the procedure in reverse.
The two glasses in the middle are special glasses
that have been treated to resist heat. They are
marked with a small dot located on a corner and a
black frame respectively.
It is important that, when refitting the oven door,
the inner glasses are fixed in the right position.
To check if this operation has been carried out
correctly, when inserting the glass, make sure that
the surface of the glass marked with a black frame
looks upwards and that the dot is located on the
upper right corner of the glass (see diagram).
DO NOT clean the oven door while the glass
panels are warm. If this precaution is not observed
the glass panels may shatter. If the door glass
panels become chipped or have deep scratches,
the glasses will be weakened and must be replaced
to prevent the possibility of the panel shattering.
Contact your local Customer Care Department
who will be pleased to advise further.
Models in stainless steel or aluminium
We recommend to clean the oven door using only a wet
sponge and dry it after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as they
can damage the oven surface. Clean the oven control
panel following the same precautions.
Oven Shelves and Shelf Supports
To clean the oven shelves, soak in warm soapy water
and remove stubborn marks with a well wetted soap
impregnated pad. Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy cleaning.
Proceed as follows:
1) remove the front screw while keeping the shelf support
in position with the other hand (see diagram 1);
2) disengage the rear hook and take off the shelf support
(see diagram 2);
3) once the cleaning is carried out, refit the shelf supports
following the procedure in reverse.
Please, ensure the retaining nuts are secure when
refitting the shelf support.
1
2
1 7
Advertisement
Table of Contents
