Setup For Operation - MK Diamond Products MK-370EXP Owners Manual, Parts List & Operating Instructions

MK-370EXP SAW

SETUP FOR OPERATION

CAUTION
1. If using an extension power cord, make sure the length and wire gauge correspond
NOTE:
to the requirements listed in on page 10. An extension power cord that is too small
in wire gauge (diameter), or too long in length, will cause the motor to overheat and
could cause premature failure.
1. Before powering or starting, check for damage that could prevent this
equipment from proper operation or performing it's intended function. Check
for binding and alignment of moving parts. Check for damaged, broken, or
missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-370EXP Saw to a power supply, be sure the
voltage, cycle and phase of the job site power source meet the requirements
of the table below.
4. Plug the MK-370EXP Saw into a wall outlet with built-in GFCI protection.
5. Do not cover the motor vents as this could lead to motor overheating.
VOLTAGE
CYCLE
PHASE
120v
60Hz
1-phase
22
SETUP