Troubleshooting - MK Diamond Products MK-370EXP Owners Manual, Parts List & Operating Instructions

MK-370EXP SAW

TROUBLESHOOTING

"Rodding" cooling channels is performed by inserting a small wire rod through the
NOTE:
cooling inlet on top of the Blade Guard and directing the rod out through each of the
cooling flow tubes located on the underside of the Blade Guard. The cooling channels
should be "rodded" until all ports are free of foreign debris.
(K)
Rod Cooling Channels and
recheck flow
BLADE STOPS TURNING
(B) (C)
(A)
Check to see if the wall outlet Check power source voltage
Verify all plugs are fully
Ground Fault Circuit Interrupter is 120v – if not 120v, move to
installed
(GFCI) is tripped. Verify circuit another circuit
breaker not tripped. If tripped,
reset once
41