Installing Your Cooker - Belling GT 755 Installation And User Instructions Manual

Installing your cooker

Unpacking After unpacking your cooker, make sure that you remove all the
packing from the ovens and grill, and any stickers from the oven
doors and hob.
Examine your cooker. Make sure there is no damage or missing items.
If there is anything damaged or missing, please contact your supplier for advice.
Sitting/Moving Prior to installation, ensure that the local distribution conditions (nature of the
the Cooker the Cooker gas and gas pressure) and the adjustment conditions are compatible.
The adjustment conditions for this appliance are stated on the rating label, which
is fitted on the plinth.
This appliance is not designed to be connected to a combustion products
evacuation device. It must be installed and connected in accordance with current
installation regulations. Particular attention should be given to the relevant
requirements regarding ventilation.
Gas
The appliance is factory set for use with Natural Gas ONLY G20 at 20mbar.
installation
It is not convertible to any other gas.
Gas Safety (Installation and Use) Regulations
It is the law that all gas appliances are installed by competent persons in
accordance with the current edition of the above regulations. It is in your interest and
that of safety to ensure compliance with the law.
In the UK, CORGI registered installers work to safe standards of practice.
This appliance must be installed and connected in accordance with current installation
regulations. Failure to install the cooker correctly could invalidate the warranty liability
claims and could lead to prosecution.
Location The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a
room containing a bath or shower. The cooker must not be installed in a bed-sitting room
of less than 20m
Levelling The appliance should be located on a level surface. The front/rear feet can be
adjusted to a maximum height of 910mm as required. To ensure that your appliance
is standing level, adjust the rear feet by turning clockwise or anticlockwise until
the rear of the product is set to the required height. Position the cooker in the
correct location and adjust the front feet by turning clockwise or anticlockwise to
ensure firm contact with the floor. Check the cooker is level using a spirit level
(Not provided). Adjust if necessary.
Provision for The room containing the cooker should have an air supply in accordance with
Ventilation current regulations in force.
The room must have an opening window or equivalent; some rooms may also
require a permanent vent. If the room has a volume between 5 and 10m
require an air vent of 50 cm
directly to outside. If the room has a volume of less than 5m
vent of 100 cm
same room, current regulations should be consulted to determine air vent
requirements.
2
.
2
effective area unless it has a door which opens
2
effective area. If there are other fuel burning appliances in the
4
3
, it will
3
, it will require an air