Before Using - Citizen D710 Instruction Manual

Before Using

Please make sure to adequately charge the
watch using the charger provided.
This watch is rechargeable.
The watch display has been turned off prior to shipment from the factory in
order to reduce power consumption by the energy storage cell of the watch.
* Remove the display seal affixed to the watch display before using the watch.
Before using, fully charge the watch by following the procedure described below.
The display can then be illuminated by performing the all-reset procedure.
* Refer to the section entitled, "Charger", for details
on the procedure for installing the 4 pcs. of size AA
alkaline batteries and the procedure for charging
the watch.
(1) Install 4 pcs. of size
AA alkaline batteries
in the charger
provided.
Charger
(2) Place the watch in the charger and
charge the watch until the LED on
top of the charger goes out. (It
takes about 7 hours to fully charge
the watch.)
* We advise recharging to be done at stable flat surface to avoid
unexpected disengagement of the watch.
(3) When the lower right button (A), upper right
button (B), upper left button (C) and lower left
button (D) are pressed simultaneously and
released, an alarm tone sounds after
"INITIALIZE" is displayed and the entire display
is illuminated (all-reset).
(4) When any one of the buttons is pressed and
released, the time and date are displayed after
"LOADING" is displayed.
(5) Correctly set the time, date and each mode by referring to the respective
sections of the instruction manual.
* Refer to "Using the Standard Mode: 1. Using the Time Mode" of this manual for
information on correcting the time and date.
(C)
(D)
LED
(B)
(A)
3