Names Of Components; Watch Display Modes (Functions) - Citizen D710 Instruction Manual

Names of Components

Display screen (full dot display)
Pressure sensor

Watch Display Modes (Functions)

Standard Mode
The watch is usually used in this mode. The standard mode consists of the following seven
modes.
1. Time Mode
In this mode, the watch displays the time and date (main time) that are the basic
parameters of this watch. This mode is normally displayed when wearing the watch.
2. Travel Time Mode
In this mode, the watch displays the time and date for a different location from the time
mode.
3. Destination Timer Mode
In this mode, the watch displays the time remaining until a preset arrival time in 1 second
units after a destination and arrival time have been preset. This convenient function can be
used when traveling or on business overseas.
* Maximum measuring range: 99 hours 59 minutes 59 seconds
4. Alarm Mode
In this mode, the watch displays the preset alarm time.
5. Chronograph Mode
In this mode, the watch measures time with a chronograph up to 99 hours, 59 minutes
59.99 seconds in 1/100-second units.
6. Timer Mode
In this mode, the watch measures time with a count down timer in 1 second units (and can
be set up to 99 minutes in 1 minute units).
7. System Monitor Mode
In this mode, the watch displays the charge level of the watch along with a general
indication of the usage status of flash memory.
24
Button (C)
Button (D)
Button (B)
Button (A)
EL light button
/
Infrared transmitter/receiver
Water sensor
(USB communication
terminal pin)
Charging terminal pin