Volvo V70 Owner's Manual page 348

08 Wheels and tyres
Changing wheels
5. Screw together the towing eye with the
wheel wrench* until the stop position as
illustrated below.
08
*
346
Option/accessory, for more information, see Introduction.
IMPORTANT
The towing eye must be screwed into all
threads in the wheel bolt wrench.
6. Loosen the wheel bolts ½-1 turn anti-
clockwise with the wheel wrench.
WARNING
Never position anything between the
ground and the jack, nor between the jack
and the car's jacking point.
7. There are two jacking points on each side
of the car. There is a recess in the plastic
cover at each point. Crank the foot of the
jack down so it is pressed squarely on the
ground.
IMPORTANT
The ground must be firm, smooth and
level.
8. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
Installation
1. Clean the contact surfaces between
wheel and hub.
2. Put on the wheel. Tighten the wheel bolts
thoroughly.
3. Lower the car so that the wheels cannot
rotate.