01 Safety; Seatbelts - Volvo V70 Owner's Manual

01 Safety

Seatbelts

01
General information
Heavy braking can have serious consequen-
ces if the seatbelts are not used. Ensure that
all passengers use their seatbelts.
It is important that the seatbelt lies against
the body so it can provide maximum protec-
tion. Do not lean the backrest too far back.
The seatbelt is designed to protect in a nor-
mal seating position.
Putting on a seatbelt
Pull the belt out slowly and secure it by
pressing its locking tab into the seatbelt
buckle. A loud "click" indicates that the belt
has locked.
The buckles only fit the intended lock in the
1
rear seat .
Certain markets.
1
16
Releasing the seatbelt
Press the red button on the seatbelt buckle
and then let the belt retract. If the seatbelt
does not retract fully, feed it in by hand so
that it does not hang loose.
The seatbelt locks and cannot be with-
drawn:
•
if it is pulled out too quickly
•
during braking and acceleration
•
if the car leans heavily.
Make sure that you:
•
do not use clips or anything else that can
prevent the seatbelt from fitting properly
•
ensure that the seatbelt is not twisted or
caught on anything
•
the hip strap must be positioned low
down (not over the abdomen)
•
tension the hip strap over the lap by pull-
ing the diagonal shoulder belt up towards
the shoulder.
WARNING
The seatbelts and airbags interact. If a
seatbelt is not used or is used incorrectly,
this may diminish the protection provided
by the airbag in the event of a collision.
WARNING
Each seatbelt is designed for only one per-
son.
WARNING
Never modify or repair the seatbelts your-
self. Volvo recommends that you contact
an authorised Volvo workshop.
If a seatbelt has been subjected to a major
load, such as in conjunction with a colli-
sion, the entire seatbelt must be replaced.
Some of the protective characteristics of
the seatbelt may have been lost, even if it
appears to be undamaged. In addition,
replace the seatbelt if the belt is worn or
damaged. The new seatbelt must be type-
approved and intended for installation in
the same position as the replaced seatbelt.