Volvo V70 Owner's Manual page 152

03 Your driving environment
®
HomeLink *
3. Depress the HomeLink
programmed, hold it depressed for
5 seconds and then release it. Repeat if
necessary until the garage door is acti-
vated. If the door is not activated, press
the programmed HomeLink
hold it depressed and check the indicator
03
lamp.
> Constant glow: The indicator lamp
illuminates with a constant glow when
the button is kept depressed, this indi-
cates that the programming is com-
plete. The garage door, gate or similar
should now be activated when the pro-
grammed HomeLink
depressed.
Glow not constant: The indicator
lamp flashes quickly for approx. 2 sec-
onds and then changes over to a con-
stant glow. In which case, continue
with the programming steps 4-6 in
order to complete the programming of
a device with rolling code (usually a
garage door opener).
4. Locate the "programming button
receiver for the garage door for example,
normally located close to the antenna's
bracket on the receiver.
Button designation and colour vary depending on manufacturer.
2
*
150
Option/accessory, for more information, see Introduction.
®
button being 5. Depress and release the receiver's "pro-
gramming button". The button flashes for
approx. 30 seconds and the next step
must be carried out within this period.
6. While the receiver's "programming but-
®
button and
ton" is still flashing, press the button on
HomeLink
it depressed for approx. 2 seconds and
then release it. Repeat the press/hold/
release sequence up to 3 times to con-
clude the programming.
Operation
When HomeLink
®
button is
be used in place of the separate original
remote controls.
Press the programmed button and hold it
depressed until the garage door, alarm sys-
tem, etc. is activated (may take several sec-
onds). Naturally the original remote controls
can still be used in parallel with HomeLink
required.
NOTE
2
" on the
If the ignition is switched off, HomeLink
will work for 30 minutes after the driver's
door has been opened.
®
being programmed and hold
®
is fully programmed it can
®
if
®
If programming problems persist, contact
®
HomeLink on: www.homelink.com or ring
00 8000 466 354 65 (or premium rate phone
number +49 6838 907 277).
®
Resetting the HomeLink buttons
It is only possible to reset all of the
®
HomeLink buttons at the same time, not
each button individually. However, individual
buttons can be reprogrammed, see the fol-
lowing section "Programming individual but-
tons".
1. Depress the two outer buttons on
®
HomeLink and do not release until the
indicator lamp starts to flash.
2. Release the buttons.
> HomeLink ®
is now set in so-called
"learn mode" and is ready to be
reprogrammed, see section "Program-
ming HomeLink®" on page 149.