Changing The Brake And Clutch Fluids; Drive Chain Slack - Yamaha XJR1300 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Changing the brake and
clutch fluids
Have a Yamaha dealer change the
brake and clutch fluids at the intervals
specified in the periodic maintenance
and lubrication chart or in the TIP after
the periodic maintenance and lubrica-
tion chart. In addition, have the oil seals
of the brake and clutch master cylin-
ders and calipers as well as the brake
and clutch hoses replaced at the inter-
vals listed below or whenever they are
damaged or leaking.
●
Oil seals: Replace every two
6
years.
● Brake and clutch hoses: Replace
every four years.
EAU22752

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the cen-
terstand.
2. Shift the transmission into the neu-
tral position.
3. Measure the drive chain slack as
shown.
1
1. Drive chain slack
Drive chain slack:
20.0–30.0 mm (0.79–1.18 in)
4. If the drive chain slack is incorrect,
adjust it as follows.
6-22
EAU22760
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Take the motorcycle off the center-
stand, and then put the sidestand
down.
EAU22794
2. Loosen the axle nut and the lock-
nut on each side of the swingarm.
3. Place the motorcycle on the cen-
terstand.
4. To tighten the drive chain, turn the
drive chain slack adjusting bolt on
each side of the swingarm in direc-
tion (a). To loosen the drive chain,
turn the adjusting bolt on each side
of the swingarm in direction (b),
and then push the rear wheel for-
ward. NOTICE: Improper drive
chain slack will overload the en-
gine as well as other vital parts
of the motorcycle and can lead
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
EAU49312
[ECA10571]