Rear Wheel - Yamaha XJR1300 Owner's Manual

To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Install the brake calipers by install-
ing the bolts.
NOTE:
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
4. Install the brake hose holders by
installing the bolts.
5. Take the motorcycle off the center-
stand so that the front wheel is on
the ground.
6. Tighten the wheel axle, the front
wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf, 52 ft·lbf)
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU33660 7. Push down hard on the handlebar
several times to check for proper
fork operation.

Rear wheel

To remove the rear wheel
G
G
1. Loosen the axle nut and the brake
1. Axle nut
2. Disconnect the brake torque rod
6-33
WARNING
It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motor-
cycle so that there is no danger
of it falling over.
caliper bolts.
from the brake caliper bracket by
removing the nut and the bolt.
EAU25080
EAU25161
EWA10820
6