Yamaha TRICKER XG250 Owner's Manual page 64

PERIODIC MAINTENANCE AND MINOR REPAIR
according to the procedure on
page 6-31.
4. Remove the axle nut, pull the
wheel axle out, and then remove
1 the wheel.
CAUTION:
2
Do not apply the brake after the
wheel has been removed together
3
with the brake disc, otherwise the
brake pads will be forced shut.
4
To install the front wheel
5
1. Install the speedometer gear unit
into the wheel hub so that the pro-
6
jections mesh with the slots.
7
8
9
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ECA11070
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
EAU24981
1
1. Retainer
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
1
6-32
Tightening torque:
Axle nut:
85 Nm (8.5 m·kgf, 61.5 ft·lbf)
6. Connect the speedometer cable.