Replacing The Air Filter Element And Cleaning The Check Hose - Yamaha TRICKER XG250 Owner's Manual

Replacing the air filter element
and cleaning the check hose
The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas. In addition,
the air filter check hose must be fre-
quently checked and cleaned if neces-
sary.
To replace the air filter element
1. Remove the seat. (See page 3-8.)
2. Remove the air filter case cover by
removing the screws.
1
1. Screw
2. Air filter case cover
PERIODIC MAINTENANCE AND MINOR REPAIR
3. Pull the air filter element out.
EAU37870
4. Insert a new air filter element into
the air filter case as shown.
3
1. Air filter element
2. Air filter case
3. Slot
CAUTION:
2
G Make sure that the air filter ele-
ment is properly seated in the
air filter case.
G
The engine should never be op-
erated without the air filter ele-
ment installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.
5. Install the air filter case cover by in-
stalling the screws.
To clean the air filter check hose
1
2
1. Air filter check hose
ECA10480
6-11
6. Install the seat.
1. Remove panel C. (See page 6-5.)
2. Check the hose on the side of the
air filter case for accumulated dirt
or water.
1
3. If dirt or water is visible, remove
the hose, clean it, and then install
it.
4. Install the panel.
2
3
4
5
6
7
8
9