Rear Wheel (For Non-Abs Models) - Yamaha FZ1-S Owner's Manual

4. Install the brake hose holder on
each side by installing the bolt and
nut.
5. Take the vehicle off the center-
stand so that the front wheel is on
the ground, and then put the side-
stand down.
6. Tighten the wheel axle, the front
wheel axle pinch bolt, and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf, 52 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
7. Push down hard on the handlebar
several times to check for proper
fork operation.
PERIODIC MAINTENANCE AND ADJUSTMENT
Rear wheel (for non-ABS mod-
els)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
3
2
1
1. Axle nut
2. Brake caliper bracket
3. Brake caliper
6-39
EAU44801 2. Place the vehicle on the center-
stand.
3. Remove the axle nut.
EWA14840
4. Loosen the locknut on each side of
the swingarm.
EAU40022
EWA10821
1. Drive chain slack adjusting bolt
2. Locknut
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a) and
push the wheel forward.
6. Remove the drive chain from the
rear sprocket.
TIP
●
If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
(a)
1 2
6