Changing The Brake Fluid; Drive Chain Slack - Yamaha FZ1-S Owner's Manual

Changing the brake fluid

Have a Yamaha dealer change the
brake fluid at the intervals specified in
the TIP after the periodic maintenance
and lubrication chart. In addition, have
the oil seals of the master cylinders and
calipers as well as the brake hoses re-
placed at the intervals listed below or
whenever they are damaged or leak-
ing.
● Oil seals: Replace every two
years.
●
Brake hoses: Replace every four
years.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU22731

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the cen-
terstand.
2. Shift the transmission into the neu-
tral position.
3. Measure the drive chain slack as
shown.
1. Drive chain slack
Drive chain slack:
20.0–30.0 mm (0.79–1.18 in)
4. If the drive chain slack is incorrect,
adjust it as follows.
EAU22760
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Take the motorcycle off the center-
EAU22794
2. Loosen the axle nut and the lock-
3. Place the motorcycle on the cen-
4. To tighten the drive chain, turn the
6-25
stand, and then put the sidestand
down.
nut on each side of the swingarm.
terstand.
drive chain slack adjusting bolt on
each side of the swingarm in direc-
tion (a). To loosen the drive chain,
turn the adjusting bolt on each side
of the swingarm in direction (b),
and then push the rear wheel for-
ward. NOTICE: Improper drive
chain slack will overload the en-
gine as well as other vital parts
of the motorcycle and can lead
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
[ECA10571]
EAU49312
6