Installation Instructions - AEG FM6300G-AN Installation And Operating Instructions Manual

Installation Instructions

Safety instructions when building in
The laws, ordinances, directives and standards in force in the country of
use are to be followed (safety regulations, proper recycling in accord-
ance with the regulations, etc.)
Installation may only be carried out by a qualified electrician.
The minimum distances to other appliances and units are to be ob-
served.
A protective floor must be installed under the appliance.
The cut surfaces of the worktop are to be protected against moisture
using a suitable sealant.
The sealant seals the appliance to the work top with no gap.
Ensure anti-shock protection through correct installation by a qualified
electrician.
Safety instructions when connecting to the electric-
ity supply
If this appliance's mains cable is damaged, it must be replaced by a spe-
cial cable (type H05BB-F Tmax 90°; or higher). The latter is available
from the Customer Care Department.
Observe electrical safety rules.
A device must be provided in the electrical installation which allows the
appliance to be disconnected from the mains at all poles with a contact
opening width of at least 3 mm
Suitable isolation devices include line protecting cut-outs, fuses (screw
type fuses are to be removed from the holder), earth leakage trips and
contactors.
Safety instructions when connecting to the gas sup-
ply
1
Warning!
When installing, the appliance must not be connected to the electrical
supply. Disconnect the mains plug or switch off or take out the fuses.
Shut off mains gas supply.
• A stop tap must be built-in between the house's gas supply and the
appliance.
• Before connecting the appliance, check whether the local connection
conditions (type of gas and gas pressure) match the appliance's set-
up.
14